Maytag Centennial Washing Machine Lid Lock Bypass

Centennial washer balance problems.

Maytag centennial washing machine lid lock bypass.

The lid will lock and the machine will enter a pump out mode for 8 minutes. The maytag centennial washer s tub. The lid latch has been a sore spot on this washer type. This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve.

Just under the unit s housing at this spot there is a solenoid which is a type of powerful electromagnet. This switch performs the same function but the lid must be locked in place for the machine to wash. The lid switch is inside the control panel if the washer is not spinning or draining then the lid switch is the problem. A simple bypass for the first type of lid switch is to simply jam a piece of wood into the switch causing it to activate the solenoid.

Set a magnet on the site where the lid lock switch meets the washer cabinet. Pausing the wash cycle is how it can be disabled. If it does not detect both water supply hoses are turned on the control detects a problem with the water pressure sensor. A lock icon appears on the front of the washer s control panel to indicate the lid is locked and also displays the current progress of the cleaning cycle depending on the model of your maytag washer.

However some washing machines come with a lid lock. The washer s lid strike attached to the lid can also swell with rust and not properly operate the lock. If you don t know that ground is always green then you don t need to do any electrical diy repairs. To bypass the lid switch disconnect it from the wire harness then put a link in on the timer side of the harness between the 2 gray wires these are the outside wires on the harness.

Most often washer lid latch problems result in the washer not starting or a fault code such as f5e1 f5e2 or f5e3.